FLEXTRIM Versatile Cove Molding – #WM93: 3/4″ x 3/4″ Flex Cove molding – 8′ ft Lengthy

Disclaimer: Own Bamboo is a reader supported website. We are a member of Amazon Affiliates and this post may contain affiliate links. Meaning Own Bamboo receives a small commission from Amazon sellers if you make a purchase through our links, at no additional cost to you. For more information please visit out Affiliate Disclaimer Page.


Worth: $24.75
(as of Oct 27,2021 15:10:10 UTC – Particulars)



.75″ x .75″ Versatile Cove (not less than 96″ lengthy – 8 ft lengthy). Gentle oak grain texture for gel staining or portray (most prospects paint this merchandise). Typical woodworking instruments can be utilized with this materials. At all times set up moulding in a relaxed place. Use development or panel adhesive repeatedly on the bottom and nails to safe moulding in place till adhesive bonds. Bear in mind – don’t use staples to lock materials, preserve nails to a minimal (no nearer than 6 inches between nails), and don’t nail nearer than 3/8 inch from fringe of moulding. Flex Trim is secure and won’t take up moisture and is right for humid environments. It’s not affected by warmth or chilly and may face up to excessive environments. ALWAYS lay out the fabric to let it calm down again into its authentic form; it is a good time to double-check molding fashion and utility. NEVER pre-finish the fabric previous to set up. The fabric could flex throughout set up and trigger fractures within the end. ALWAYS make sure that the floor you might be making use of the fabric to is flat and clean. Versatile molding will observe any irregularities within the floor. NEVER use staples or nails with giant heads. Hold nails to a minimal and away from edges to keep away from “bumps” on the edge. ALWAYS use a development adhesive along with (or in lieu of) nails or screws. This can guarantee a fast and straightforward utility and a cleaner completed look.

.75″ x .75″ Versatile Cove (not less than 96″ lengthy – 8 ft lengthy). Gentle oak grain texture for gel staining or portray.
MADE IN THE USA!!! Materials is versatile polyurethane resin – Will bend/flex to suit a minimal radius of 6″ inches
For inside and exterior use – is not going to warp, rot or crack when uncovered to excessive moisture
Will be put in with regular woodworking instruments, is available in a light-weight tan shade

Leave a Reply

Your email address will not be published. Required fields are marked *